Basement Radon Levels, EPA Zone & Test Meaning in Hillsborough, FL
Basement test answer: Hillsborough sits in the gray zone. The map helps, but your own reading matters more than the countywide signal.
Treat the map as a hint, not the answer
Zone 2 is the gray area. A real reading is what decides whether you retest, track, or price mitigation.
Gray-zone county signal. Some homes stay low, others cross the EPA line.
2.0-3.9 pCi/L usually means retest or track. 4.0+ is where EPA action and quote planning start to matter.
No reading: test first. Borderline results often need retest or long-term tracking.
Measured Radon Data
Hillsborough evidence before the next step
Hillsborough, FL has more than the EPA map: CDC Tracking Network exposes 2,806 reported tests, 2.5 pCi/L county average, 1.3 pCi/L median, 18.1% of reported tests at or above 4.0 pCi/L, and 100.5 pCi/L high-end signal for 2008-2017.
Source window
2008-2017
Processed verdict
Borderline measured burden
High confidence - 93/100
Primary result
2.5 pCi/L
77th percentile in-state
4.0+ signal
18.1%
77th percentile in-state
High-end signal
100.5 pCi/L
92nd percentile in-state
County-specific verdict
Hillsborough is a retest-and-watch market, not a dismiss-it market.
Hillsborough is a confirmation case because 2.5 pCi/L average, 1.3 pCi/L median, and 18.1% of reported tests at or above 4.0. In-state rank: 77th percentile for average, and 77th percentile for 4.0+ share. A 2.0-3.9 result should not be treated as final without a follow-up test or longer-term read.
Real-estate use
Buyer or seller use: use the county signal to justify a test contingency or retest, then reserve credits for confirmed 4.0+ home results.
Hillsborough is a split-decision county: no reading means test first, 2.0-3.9 means retest or track, and 4.0+ means cost planning starts.
Choose Next StepBorderline-intent answer
What does a borderline radon result mean in Hillsborough?
Hillsborough is a split-decision county. 18.1% of reported tests at or above 4.0 pCi/L, 2.5 pCi/L primary measured result, and 100.5 pCi/L high-end signal means a 2.0-3.9 pCi/L home result should be retested or tracked instead of dismissed.
Pick the situation that matches you
You should not need to read the whole guide before clicking one of these. Start with the lane that matches your current stage, then come back for the deeper reference only if you still need it.
Jump into a prefilled Hillsborough action plan based on the result you already have, instead of starting from a generic cost page.
I have not tested yet
Do not price mitigation blind. Get the first number, then decide whether you need monitoring, quotes, or nothing at all.
My result is 2.0-3.9
Usually retest or track first. If the reading keeps showing up, use the local action plan to decide whether pricing makes sense.
My result is 4.0+
This is the EPA action line. Use the local cost page before calling contractors so you know the likely scope, timing, and budget.
I am buying or selling
Turn the reading into a credit or repair number before negotiation starts. This is the faster path than arguing from a generic article.
Already tested once and just want to watch the number trend?
View Airthings Corentium HomeAffiliate disclosure: we may earn a commission if you buy through these links.
County Evidence Snapshot
Hillsborough testing context
Hillsborough is a gray-zone county: the EPA map is useful context, but the local housing profile and your own home test decide the next step.
EPA map signal
Zone 2
County-level predicted indoor screening range, not a home-level test result.
Housing base
606,334
96th percentile among 67 FL counties with data.
Older housing share
68.1%
49th percentile in-state; older homes often need clearer test placement decisions.
Median home value
$294,900
Used as context for whether mitigation is a small maintenance item or a negotiation issue.
Measured Radon Data
CDC Environmental Public Health Tracking Network Radon Tests from Labs
2008-2017
Average result
2.5 pCi/L
At or above 4.0
18.1%
Maximum reported
100.5 pCi/L
10-year tested
2,806
CDC county summaries are based on national radon testing laboratories and participating state feeds; they are not a statistically designed survey of every home.
RadonVerdict Processed Verdict
Borderline measured burden
Primary result rank
77th percentile
2.5 pCi/L
4.0+ rank
77th percentile
18.1% at or above 4.0
High-end rank
92nd percentile
100.5 pCi/L
Test volume rank
95th percentile
2,806 over 10 years
How to use this county data
Data source
National tracking data
CDC Tracking provides comparable county-level measurement fields; state-specific sources still outrank it when they expose stable county tables.
What the numbers show
Fuller county picture
This is the most useful setup: county average, 4.0+ share, high-end readings, and 2,806 reported tests/properties can be read together instead of relying on one number.
Nearby comparison
Nearby comparison: Closest counties by county average: Walton County (2.3 pCi/L) is just lower, and Citrus County (2.6 pCi/L) is just higher.
How this helps
Use this for 2.0-3.9 pCi/L results, where retesting is usually smarter than dismissing the issue.
What the data says
Hillsborough, FL is measurement-backed for 2008-2017. The measured average is 2.5 pCi/L, and 18.1% of reported results are at or above 4.0 pCi/L. The high-end signal reaches 100.5 pCi/L.
Hillsborough, FL sits at the 77th percentile for measured average, 77th percentile for 4.0+ share, 92nd percentile for high-end readings, and 95th percentile for test volume among 67 measured counties in the state. Closest counties by county average: Walton County (2.3 pCi/L) is just lower, and Citrus County (2.6 pCi/L) is just higher.
What to do with it
Hillsborough is a split-decision county: no reading means test first, 2.0-3.9 means retest or track, and 4.0+ means cost planning starts.
Retest trigger: a 2.0-3.9 pCi/L home result is exactly the gray zone for this county; retest before ignoring it or paying for mitigation.
High confidence (93/100) from CDC Tracking Network based on about 2,806 reported tests/properties plus comparable county-level measurement fields.
No reading yet
No reading yet: start with a test kit; the county data is context, not a substitute for the home result.
2.0-3.9 result
2.0-3.9 pCi/L: retest or monitor before paying for mitigation, then escalate if the level repeats or rises.
4.0+ result
4.0+ pCi/L: use the result for mitigation quotes, repair scope, or seller-credit negotiation; the county signal is no longer the deciding input.
Source hierarchy: CDC Tracking Network is used for this county, with EPA zone and Census housing data kept as supporting context. CDC Tracking provides comparable county-level measurement fields; state-specific sources still outrank it when they expose stable county tables.
Direct Answer
What radon risk level should homeowners assume in Hillsborough?
Hillsborough is currently categorized as EPA Zone 2 (Moderate Risk). Test all lived-in levels and confirm with follow-up testing if elevated.
| Evidence | Value |
|---|---|
| Area | Hillsborough, FL |
| EPA Zone | Zone 2 |
| Primary Recommendation | Perform direct radon testing in the lowest livable level |
Your Radon Reading
Enter your home's measured level; the starting value is only a planning example until you have your own result.
Elevated - Consider Action
Your reading is below the US EPA action level (4.0 pCi/L), but this range still warrants follow-up testing. The World Health Organization uses 2.7 pCi/L as a tighter reference point.
If this was just a one-time snapshot, confirm it with another test or with longer tracking. If this level persists, planning mitigation is reasonable, especially for homes with frequent basement use, children, or pending real-estate transactions. Scroll down to see your estimated cost.
Understanding Radon Levels: Complete Reference
Below 2.0 pCi/L - Lower Concern, Keep Testing
Below both the EPA (4.0) and WHO (2.7) action reference levels. This usually means mitigation is not the next immediate step after a confirmed result. The average outdoor radon level is approximately 0.4 pCi/L, and there is no known risk-free indoor level. Periodic testing is still recommended because levels can change over time due to seasonal variations, changes in home ventilation, or foundation settling.
-4.0
2.0 - 4.0 pCi/L - Elevated, Consider Action
Exceeds the World Health Organization's reference level of 2.7 pCi/L but falls below the US EPA action threshold. The EPA states that homeowners should "consider fixing" homes in this range, especially if the home has a basement used as living space, if children are present, or in connection with a real estate transaction. Practical next step: run a confirmatory long-term test, then compare mitigation quotes if levels remain elevated.
-8.0
4.0 - 8.0 pCi/L - Action Recommended
Exceeds the EPA action level of 4.0 pCi/L. The EPA and Surgeon General strongly recommend mitigation within a few months. At this level, prioritize confirmatory testing and contractor planning. Standard sub-slab depressurization systems typically reduce indoor levels by 80-99%.
Above 8.0 pCi/L - Urgent Action Required
At these levels, the EPA recommends expedited mitigation - ideally within weeks, not months. Occupants should minimize time in lower-level rooms until the system is installed. Use a certified mitigator and request priority scheduling to shorten high-exposure time. Many mitigators offer priority scheduling for homes above 8.0 pCi/L.
Why Radon is Worth Monitoring in Hillsborough
Hillsborough falls in EPA Zone 2, where the predicted indoor screening range is between 2.0 and 4.0 pCi/L. Even when the countywide map signal sits below the EPA action level, geological variability means that some individual homes will still test above 4.0 pCi/L.
The soil composition in this area typically includes a mix of sedimentary formations that can contain moderate uranium deposits. Homes with basement or crawlspace foundations are particularly susceptible, as they provide more pathways for soil gas entry.
The World Health Organization recommends action at 2.7 pCi/L - well below the US EPA threshold. If you have children, spend significant time in below-grade rooms, or are buying/selling a home, testing is essential even in a Zone 2 area.
Radon & Health: What the Science Says
lung cancer
from radon
4.0 pCi/L
Radon is a Class A carcinogen - the same classification as asbestos and tobacco smoke. The National Academy of Sciences estimates that radon causes approximately 21,000 lung cancer deaths annually in the United States, making it the leading environmental cause of cancer death.
Unlike smoking, radon exposure is involuntary and often invisible. There is no safe level of radon - risk increases linearly with exposure. The good news: radon mitigation systems are highly effective, typically reducing indoor levels by 80-99% within hours of activation.
Source: US Environmental Protection Agency, "A Citizen's Guide to Radon" (EPA 402/K-12/002). National Academy of Sciences, Biological Effects of Ionizing Radiation (BEIR VI) Report, 1999.
Step 1: Test Your Home
Testing is the only way to know your home's radon level. Zone data tells you the regional risk, but your home could be significantly higher or lower than the countywide pattern. For most homeowners, the right first purchase is a low-cost short-term test kit.
A digital monitor is a better fit after your first result, for seasonal re-checks, or to keep tracking levels after mitigation.
View Airthings Corentium HomeAs an Amazon Associate, RadonVerdict earns from qualifying purchases.
Already Know Your Level?
If your test shows 4.0 pCi/L or higher, get an itemized cost estimate specific to Hillsborough - including regional labor rates and permit requirements.
Get Mitigation Cost Estimate ->FL Radon Regulations
Florida does not mandate radon disclosure in real estate transactions, but the Florida Building Code requires radon-resistant construction in Zone 1 counties.
Florida does not require state licensing for radon professionals. Look for NRPP or AARST-certified professionals.
How to Test for Radon in Hillsborough
Buy a Test Kit
Purchase a short-term charcoal test kit online or from a local hardware store. Cost: $15-$30. Place it in the lowest livable level of your home.
Wait 2-7 Days
Keep doors and windows closed (except normal entry/exit) during the test period. Avoid running whole-house fans. Mail the kit to the lab provided.
Read Your Results
If results are below 4.0 pCi/L, re-test every 2 years or use a monitor for ongoing tracking. If above 4.0, use our cost calculator to see mitigation options.
Related Radon Resources for Hillsborough
Explore Other FL Counties
Official State Resource
Florida radon program and rules
Use the state program link to verify local radon guidance, disclosure language, and contractor credential expectations before you act on an estimate.
Disclosure note
Florida does not mandate radon disclosure in real estate transactions, but the Florida Building Code requires radon-resistant construction in Zone 1 counties.
Credential note
Florida does not require state licensing for radon professionals. Look for NRPP or AARST-certified professionals.
Sources & Methodology
Radon zone classifications for Hillsborough are sourced from the EPA's Map of Radon Zones, which uses geological surveys, indoor radon measurements, and soil permeability data to assign each county a risk tier.
Disclaimer: Zone data represents county-level screening ranges and cannot predict the radon level in any specific home. Testing is the only reliable method to determine your home's radon concentration. This content is for informational purposes and is not medical advice.
Content review: Source-level retrieval dates
Editorial and Data Transparency
- Author
- RadonVerdict Data Team (Public Data and Cost Modeling)
- Content Review
- Source-level dates shown below
- Data Retrieved At
- 2026-02-24
Primary Sources
- EPA Map of Radon Zones (retrieved 2026-02-21)
- EPA A Citizen's Guide to Radon (retrieved 2026-05-05)
- CDC Environmental Public Health Tracking - Radon Testing (retrieved 2026-05-05)
- Official FL radon program
- US Census Bureau, 2018-2022 American Community Survey 5-Year Estimates (retrieved 2026-02-24)